Air belt separator BBS

The separator classifies the input material in a light weight and a heavy weight fraction. The input material has to be free of fines and oversizes as far as possible. The input material has to be free- owing and may not agglutinate. For a good separation results, the ratio of the smallest to the largest particle should be 1: 4.

The input material must be evenly distributed on the acceleration belt. Under the head of the accelerating belt a nozzle is placed. The input material passes this nozzle in free fall. Very light components are blown out of the stream over the arch belt directly into the settling chamber. In the transfer area, very heavy parts fall down on a heavy material discharge belt. All other parts reach the arch belt. Over the radius of the arch belt they are also separated into light and heavy fractions.

In the settling chamber the light fraction is separated from the air stream. Due to calming of the air, the light particles can settle here and are discharged by the light material discharge belt.

The separator operates in recirculation mode. A second fan extracts the dust-laden air through a filter from the settling chamber and transfers the cleaned air to the surroundings. The separated dust is supplied to the light material fraction.

  • High recovery rate of light fraction
  • A lot of setting options allow an optimal separation result
  • Integrated filter unit



Technical data

Working data BBS 10 BBS 16
Working width 1,000 mm 1,600 mm
Troughput up to 100 m³/h up to 160 m³/h
Length total 9,200 mm 9,200 mm
Width total 1,800 mm 2,400 mm
Height total 4,600 mm 4,600 mm
Installed electrical power BBS 10 BBS 16
Arch belt 2.2 kW 2.2 kW
Fan for nozzle 15.0 kW 22.0 kW
Fan for underpressure generation 7.5 kW 5.0 kW

Downloads

BRT HARTNER Sorting Systems

BRT HARTNER Sorting Systems